Recent content by M Porter

Thanks for all the answers. I stated that I had a Metro air attachment in error. It is actually a Tornador attachment. I too did not find it worked that well. One thing I did learn with it was that I had to turn down the air pressure. I am away at the moment, but once back I will be exploring...

The last vehicle that came in with paint on it, I tried Goof Off (graffiti remover) and a plastic razor blade with great success.

Due to living in a very rural area, I am faced with largeamounts of gravel on the vehicle floors. After vacuuming there are alwaysgreat quantities of sand still left deep within the carpet. At present I vacuum (6 HP) thecarpet numerous times using both a brush (agitate carpet) and rubber mallet...

Due to the way society is today, they would have a warning label on the spoiler. It would show that you should not sit on it while the car is in motion. Go Figure ;)

Thanks for all the replies. I am looking to use it on the interior for the cloth seats (when extracting), dash and doors. I guess my next step would be to check the suggested products reviews.

Saw these pictures on the net and thought I would share them. Can you imagine the damage if you did anything similar to one of todays vehicles.

I am looking for a new APC. I have been using Optimum Power Clean, but find that I do not like the smell that it leaves. The smell does remind me of something that is not very pleasant. Smell is very subjective, so I will refrain from stating it here. I must add that I am very pleased with OPC...

I saw this on another forum and found it amusing. Hopefully others do also.

Thanks to everyone for responding. Since doing that truck, I have started using a sponge to spread the product. In the future I will adapt a number of the suggested I have received.

Before applying IronX I always give the vehicle a good wash. To cut down on the amount of product used, I will do as suggested and clay before instead of after. Thanks.

I clayed after the applications. I know the owner personally, but I am concerned that there could be an issue with others in the future. Due to the amount of IronX used, I doubt that someone else would appreciate the amount of cost and work involved. Mike

Hi I am wondering if I could have done something different. The truck is used for pulling a trailer, which explains the build up of brake dust. It took me four applications of IronX before the truck was decontaminated. Obviously it was a costly procedure and luckily the customer was not hesitant...

When I owned a school bus company one of my drivers (from out of town) mentioned that she was helping her husband with their truck. They had been using WD40. She had arthritis quite bad in her hands and noticed (once back in the house) that the pain had completely disappeared. At that time I...

I am not certain if this is of any use to you. Whenever I have done any wood varnishing, to eliminate lap marks I do the following. I put the varnish in a small plastic container and then have it floating in a second larger container. The second container has hot tap water in it. Due to the...

Excellent, could I get a copy, [email protected]