Search results

How To

How To

Good Morning! Yes you can indeed apply a second layer of SKIN. Pay extra close attention to the removal process and use a bit less product than the first layer. I was able to get SKIN to streak fairly easily when I gave this a try because the initial layer is so slick and repellent. But if I...

Bathe+ can be used over any coating and over non coated vehicles as well. No exclusions. Just be sure to wash a section at a time and rinse immediately so the soap isn't allowed to dry anywhere on the vehicle.

Hello! The high humidity will affect only the removal time of SKIN. I would be looking to remove the coating a touch faster than if we were in a low humidity environment. I would also wipe each panel with an absorbent microfiber to make sure the working area is as dry as possible (no moisture in...

We have a large Ocean Order landing the first week of April and will be restocking everyone!

I have not seen that yet personally. Let me run an email up to GYEON HQ and see if it has showed up anywhere else and what the cause may be.

Hello! It is certainly best to remove the base coating completely and start fresh. You want a clean and fresh bond with the paint surface underneath. New Mohs would certainly bond to "old" Mohs and perform well, but best to start fresh where we can. The old coating will not flake or peel off...

Good Afternoon! SYNCRO will perform fine over gelcoat. I would expect to use bit more Mohs than you would an automotive paint as the gelcoat will absorb more, but no issues other than that. Minimum temperature would be around 55-60 degrees F. The real issue is that it will take much longer...

Hey Guys. Worst case scenario, the streaks or high spots from Cure can be removed with a very fine polish like GYEON Primer, which will leave a layer of SiO2 behind and not overly affect the coating underneath. It really depends on how heavy the streaks are. I have seen a simple wipe down with...

Ahhhhh I see. Because I addressed him as Joaquin mistaking his quote as a signature. Good one.

Thanks Bob. The procedure mentioned in the product description will absolutely work. But if someone isn't having luck with that method, should I not provide an alternate? You can absolutely spray Cure directly on to paint and work it in. If someone is seeing streaks it is 9/10 because of too...