KMG
New member
- Aug 26, 2013
- 661
- 0
This car belongs to a family member that lives in Virginia and was in desperate need of a thorough cleaning inside and out. I went down to visit for the weekend and looked at the car, and after some discussion we had settled on my Americoat Package with a Single-Stage Paint Correction along with a Standard Interior Detail.
Pictures Of The Car As It Arrived
As you can see in the above picture the vehicle was quite dirty with debri from a tree that it is parked under daily.
Another image showing the debri on the hood and road grime build up on the front of the vehicle.
Image of a stain on the passenger side rear quarter panel. There were stains like this all over the car.
Image showing the interior, which was in need of a good wipe down from dust and dog hair.
Close up of the radio showing just how dusty it was.
These floor mats did a great job keeping the carpets clean and hold most of the debri build up on them. Although there was still a good amount of dog hair on the carpet areas around the mats.
Driver side floor
Image showing the cluster which was also quite dusty.
The Washing Process
Foam Pre-treatment: Chemical Guys Citrus Wash & Clear
Wheels: Americana Car Care Ameririd w/ wheels whoolies & mothers brushes
Protected with Hydr02 Silica Spray Sealant
Tires: Tuff-shine Tire Cleaner, coated with CarPro PERL 1:1
Decon: Carpro Lemon IronX
Nanoskin Autoscrub Speedy Prep Sponge w/ ONR
2 Bucket Wash: Chemical Guys Citrus Wash & Clear w/ Sheepskin wash mitt
Coating: Americoat Acrylic Coating on Painted Surfaces
Trim: Coated with Americoat
Drying: Metro Air Force Blaster
Image of the foam pre-treatment early in the morning
Image of IronX breaking down the iron deposits on the grille. The car was covered with surface contaminates like this.
Wheels after they were cleaned with Ameririd and Citrus Wash and Clear shampoo.
They were then treated with Hydr02 spray sealant for enhanced protection and gloss.
Condition Of Paint After Being Cleaned
This image is of the passenger side rear quarter panel and tail light. As you can the car is heavily swirled.
Another image of the passenger side of the vehicle.
Another image of the passenger side of the vehicle.
Image of the passenger side door and front fender. This was the condition that the paint was in on the entire vehicle.
Single-Stage Paint Correction Process
I performed a test spot using my Rupes LHR 15 and Americana Car Care Ameridepth w/ a 5.5" white (polishing) Lake Country flat pad. This combination was providing the desired correction I was looking for while and finished down very nice and glossy on this white paint. This is the process I used on the rest of the car. I used my Rupes 75E with 3" white (polishing) Lake Country flat pads in the tighter areas of the car
Image showing the passenger side doors after polishing with Ameridepth.
Image of the nice gloss and reflective qualities after polishing.
Image showing what the paint looked like under the door handles prior to polishing.
Image of the same door handle after being polished by hand to remove the surface scratches.
Image of the hood after polishing with Ameridepth.
Final Product After Americoat Coating
This image was taken the morning after I applied the coating and let it sit over night. The gloss was amazing for a white car.
The white was very intense and almost seems to glow in bright sunlight now.
Interior Cleaning Process And Final Product
The inteior of the vehicle wash thoroughly swept and the carpets were brushed with a rubber brush to remove the dog hair. The seats all and the panels were scrubbed with Meguiars APC+ leaving a nice clean surface. The interior trim was then dressed with Meguiars Quik Interior Detailer, and the seats were treated with Lexol Leather Conditioner.
Image of the driver side after being cleaned and treated.
Image of the rear seating area after being cleaned.
As usual thanks for looking!
Pictures Of The Car As It Arrived
As you can see in the above picture the vehicle was quite dirty with debri from a tree that it is parked under daily.
Another image showing the debri on the hood and road grime build up on the front of the vehicle.
Image of a stain on the passenger side rear quarter panel. There were stains like this all over the car.
Image showing the interior, which was in need of a good wipe down from dust and dog hair.
Close up of the radio showing just how dusty it was.
These floor mats did a great job keeping the carpets clean and hold most of the debri build up on them. Although there was still a good amount of dog hair on the carpet areas around the mats.
Driver side floor
Image showing the cluster which was also quite dusty.
The Washing Process
Foam Pre-treatment: Chemical Guys Citrus Wash & Clear
Wheels: Americana Car Care Ameririd w/ wheels whoolies & mothers brushes
Protected with Hydr02 Silica Spray Sealant
Tires: Tuff-shine Tire Cleaner, coated with CarPro PERL 1:1
Decon: Carpro Lemon IronX
Nanoskin Autoscrub Speedy Prep Sponge w/ ONR
2 Bucket Wash: Chemical Guys Citrus Wash & Clear w/ Sheepskin wash mitt
Coating: Americoat Acrylic Coating on Painted Surfaces
Trim: Coated with Americoat
Drying: Metro Air Force Blaster
Image of the foam pre-treatment early in the morning
Image of IronX breaking down the iron deposits on the grille. The car was covered with surface contaminates like this.
Wheels after they were cleaned with Ameririd and Citrus Wash and Clear shampoo.
They were then treated with Hydr02 spray sealant for enhanced protection and gloss.
Condition Of Paint After Being Cleaned
This image is of the passenger side rear quarter panel and tail light. As you can the car is heavily swirled.
Another image of the passenger side of the vehicle.
Another image of the passenger side of the vehicle.
Image of the passenger side door and front fender. This was the condition that the paint was in on the entire vehicle.
Single-Stage Paint Correction Process
I performed a test spot using my Rupes LHR 15 and Americana Car Care Ameridepth w/ a 5.5" white (polishing) Lake Country flat pad. This combination was providing the desired correction I was looking for while and finished down very nice and glossy on this white paint. This is the process I used on the rest of the car. I used my Rupes 75E with 3" white (polishing) Lake Country flat pads in the tighter areas of the car
Image showing the passenger side doors after polishing with Ameridepth.
Image of the nice gloss and reflective qualities after polishing.
Image showing what the paint looked like under the door handles prior to polishing.
Image of the same door handle after being polished by hand to remove the surface scratches.
Image of the hood after polishing with Ameridepth.
Final Product After Americoat Coating
This image was taken the morning after I applied the coating and let it sit over night. The gloss was amazing for a white car.
The white was very intense and almost seems to glow in bright sunlight now.
Interior Cleaning Process And Final Product
The inteior of the vehicle wash thoroughly swept and the carpets were brushed with a rubber brush to remove the dog hair. The seats all and the panels were scrubbed with Meguiars APC+ leaving a nice clean surface. The interior trim was then dressed with Meguiars Quik Interior Detailer, and the seats were treated with Lexol Leather Conditioner.
Image of the driver side after being cleaned and treated.
Image of the rear seating area after being cleaned.
As usual thanks for looking!
