3M Clear Bra Removal - Any Suggestions?

Totoland Mach

Totoland Mach

New member
Joined
Mar 3, 2006
Messages
1,142
Reaction score
0
I've got to remove the 3M clear bra from the Hood/Front Fenders/Front Bumper of a Ferrari (black of course) 360 Stradale. I'm thinking of using a small Scanuci portable steamer to get some heat to the material without damaging the paint.

Any tips from the "Geeker's" out there. I start tomorrow morning.

Toto
 
You should be able to just get under a corner of it and pull it off. If its semi cold (cool) you may want to use a heat gun or a hair drier to warm it up to soften the adhesive a little.

How long has it been on the car?
 
It's supposed to be cold tomorrow, but the shop is heated. I suppose it's been on the car a few years at least.

Toto
 
I would for sure warm it up some. But it should come off without a whole lot of troubles. I removed one from a porsche a couple years ago that had been on for about 2 years that pulled off without too much fuss. I did have to warm it up some though.
 
I'll second that, just add a bit of heat (I used a steamer) and get a corner to lift off and it comes off pretty easily.
 
Thanks Everyone! Just wanted to "cross the T's and Dot the i's"

Toto
 
Putting the car inside a heated shop and maybe pointing a couple of halogen
lamps at it (they throw off a lot of heat) should make it quite easy to remove
the film.
 
Ed, you hidding info from the rest of us. haha.... Just givin ya a hard time. Did you find something different?
 
Once you get a edge off than you should be able to pull the hole thing off.
The film is designed to release easily.
 
You must log in or register to reply here.
Back
Top