Moedizzle
New member
- Jan 21, 2009
- 22
- 0
A few weeks ago I acquired this 04 Acura TL to utilize as a daily driver. The motor of the car was meticulously maintained and it only had 75000 miles. Unfortunately, the exterior had never been detailed and the headlights were in need of a good correction to allow the HID lights to fully do their job. I also decided to detail the engine bay as it looked as it had never been detailed as well. Full paint correction is in the books within the next few weeks.
Engine Process:
P21s TAW on painted surfaces
APC+ 4:1 to degrease motor
303 Aerospace on plastic surfaces and hoses
CG B2B on hard to reach hoses
Before

After


Headlight Process:
Wetsand with 1500, 2000, 2500 grit sandpaper
Flex 3401
Menzerna SIP on Orange Pad
Menzerna SF on White pad
Blackfire Crystal Seal Sealant for protection
Before


Wetsand in progress

After SIP

Completed with SIP and SF

After a quick car wash and Blackfire Crystal Seal Sealant applied to the headlights

Engine Process:
P21s TAW on painted surfaces
APC+ 4:1 to degrease motor
303 Aerospace on plastic surfaces and hoses
CG B2B on hard to reach hoses
Before

After


Headlight Process:
Wetsand with 1500, 2000, 2500 grit sandpaper
Flex 3401
Menzerna SIP on Orange Pad
Menzerna SF on White pad
Blackfire Crystal Seal Sealant for protection
Before


Wetsand in progress

After SIP

Completed with SIP and SF

After a quick car wash and Blackfire Crystal Seal Sealant applied to the headlights
