panthercz
New member
- Nov 17, 2010
- 309
- 0
The last two winters here dumped a ton of snow and couple that with the wind, I ended up battling 34" inch drifts that were up to 25 feet long. So last year I bought a big Ariens snowblower with upgraded Subaru SX30 engine and it worked wonderfully.
I then decided that today I would completely coat my Ariens Deluxe 30" inside and out with Opti-Coat 2.0. The reason for this is of course for protection but more importantly, I'm hoping the hydrophobic properties of Opti-Coat will help prevent snow and slush from building up inside the machine while using it. It wasn't a real problem last year but I want the machine to operate as efficiently as possible.
I also wanted to get it done well before winter arrives since I've seen it mentioned several times that Opti-Coat takes 90 days to fully cure.
Began by rinsing the snowblower off with the hose.
Then saturated it with Optimum Power Clean at full strength and let dwell. After a few minutes I sprayed more OPC onto a MF towel and wiped everything down. Then rinsed again.
After drying I grabbed some Opti-Coat and began coating every surface I could reach (except the tires).
All done and nice and clean.
Used about 2 CC of Opti-Coat to completely coat everything, inside and out.
I then decided that today I would completely coat my Ariens Deluxe 30" inside and out with Opti-Coat 2.0. The reason for this is of course for protection but more importantly, I'm hoping the hydrophobic properties of Opti-Coat will help prevent snow and slush from building up inside the machine while using it. It wasn't a real problem last year but I want the machine to operate as efficiently as possible.
I also wanted to get it done well before winter arrives since I've seen it mentioned several times that Opti-Coat takes 90 days to fully cure.
Began by rinsing the snowblower off with the hose.

Then saturated it with Optimum Power Clean at full strength and let dwell. After a few minutes I sprayed more OPC onto a MF towel and wiped everything down. Then rinsed again.

After drying I grabbed some Opti-Coat and began coating every surface I could reach (except the tires).

All done and nice and clean.





Used about 2 CC of Opti-Coat to completely coat everything, inside and out.