CCS Euro Hand Pads

Paulyfe12

Paulyfe12

New member
Joined
Apr 23, 2014
Messages
149
Reaction score
0
I am ordering a Griots DA polisher a 6 inch backing plate and a 3 inch backing plate. But for those tight sports where I cant use a DA im thinking about ordering some CCS Euro Hand compound and polishing pads. So im curious if anyone has used them and if the are effective. Also im curious as to how you could clean up headlights and taillights in terms of eliminating fine scratches. Could I treat them the same as paint and polish them up? or would that be too abrasive?
 
Paulyfe12 said:
I am ordering a Griots DA polisher a 6 inch backing plate and a 3 inch backing plate. But for those tight sports where I cant use a DA im thinking about ordering some CCS Euro Hand compound and polishing pads. So im curious if anyone has used them and if the are effective. Also im curious as to how you could clean up headlights and taillights in terms of eliminating fine scratches. Could I treat them the same as paint and polish them up? or would that be too abrasive?
Click to expand...

Yes and yes

and Yes>

the ccs hand pads are very effective and I have a several of them and would not be without them.

I typically treat tail lenses and headlights with what ever I'm using for compounding and polishing......unless they are in very bad condition then I'll break out the sanding disks.
 
oh ok nice, what would your recommended technique be for using the Euro pads? what direction, pressure, time taken to rub the product in. anything you can tell me
 
the same pattern as you would with a DA, makes sense thanks
 
Paulyfe12 said:
I am ordering a Griots DA polisher a 6 inch backing plate and a 3 inch backing plate. But for those tight sports where I cant use a DA im thinking about ordering some CCS Euro Hand compound and polishing pads. So im curious if anyone has used them and if the are effective. Also im curious as to how you could clean up headlights and taillights in terms of eliminating fine scratches. Could I treat them the same as paint and polish them up? or would that be too abrasive?
Click to expand...

the GG6 comes with a 6" backing plate, so order a 5" and 3.5". Then you can use 6.5", 5.5", and 4" pads. The 4" pads work great for headlights and tail lights and smaller areas that are tougher to get with the larger pads. Then use the hand pads that you can't reach with the 4" pads. I have the orange, white, and red ccs hand pads and use them all the time.
 
do the hand pads wear out? or do you simply need to wash and dry them? Ive always wondered how long do the pads for a polisher and hand pads last before they need to be replaced. not during a polishing process, but like all together, like throw it in the garbage and buy new ones
 
The hand pads should last a long time unless you are doing a whole car with them. If you are just doing a few tight spots each detail, they won't get much wear. Just clean like regular polishing pads. I use all purpose cleaner, let them soak a few minutes, then rinse and wring out. To dry I put them face down on a grit guard for a few days, then into a ziploc bag until next time.

As for the machine pads, I usually clean them and then take a look at them after they have dried to determine if I can use them again. If they look near new, then I re-use them. If there are any chunks out or I can see some general wear on the face of the foam, or there is any deformity in the shape, then I will toss.
 
You must log in or register to reply here.
Back
Top