CG blacklight?

Anthony@zerboautoworks

Anthony@zerboautoworks

New member
Joined
Nov 21, 2012
Messages
789
Reaction score
0
What pad should I use with BL? I want a little cleaning ability would CCS white polishing foam pad do what I need?

Thanks guys
 
Anthony@zerboautoworks said:
I have a gg6, I don't want to buy a smaller backing plate.
Click to expand...


I have a GG6 as well 3rd gen with a 5" backing plate and recommend you pick up a new backing plate.

5.5 pads are much easier to work with :xyxthumbs:


I have used blacklight with both White pads and Black pads

I would think a white or green pad would work perfect for you!
 
Jrocket said:
I have a GG6 as well 3rd gen with a 5" backing plate and recommend you pick up a new backing plate.

5.5 pads are much easier to work with :xyxthumbs:


I have used blacklight with both White pads and Black pads

I would think a white or green pad would work perfect for you!
Click to expand...

Which 5" backing plate did you use on your gg6?
 
Any good finishing pad will work. Speed 3-4 on a PC polisher. Don't spin it like you would correcting paint. Work it slowly and not a lot of pressure.
 
+1 for 5.5" pads!

I use black light with black or blue LC pads.
 
I went ahead and got the 5 inch backing plate and the 6 pack of 5.5 inch pads. I am super excited to use the combo BL+Pete's 53+V7.
 
If you want to add a twist put some black wax from CG on before the Petes '53. Stunning deepness!
 
does blacklght remove existing lsps? or is more like wetglaze 2.0? crs
 
I have a black truck. Would it be save to top black light with Wolfgang deep gloss paint sealant 3.0?
 
BL is more commonly topped with a wax (or V7), but you should be fine using WDGPS3.0 after allowing BL to cure for a bit.
 
BuckeyeR/T said:
No worries, I just didn't want you to think you had to have the smaller backing plate to have success with BL.
Click to expand...

Actually, I have been wanting to down size on my pads. I feel 6.5 inch pads are too big for the job at hand, as far as correction goes even know the GG6 has power the smaller backing plate would benifit me more. I am sure the 5.5 " inch pads will be better.
 
I tend to prefer applying BL by hand, unless I'm looking to use it for its filling abilities.
 
You must log in or register to reply here.
Back
Top