lazyjet
New member
- Aug 21, 2012
- 188
- 0
Got my first DA polisher (GG6") at the beginning of this year got lucky to as it was during the xmas day %15 off everything sale
Black Honda Fit
Started out with the rims
wolfgang wheel and tire cleaner, CG all clean + APC, and variety of brushes
Door jams, crevices and gas cap area cleaned using APC and detailing brush
Heavily soiled areas sprayed with APC and let to dwell for a bit before foaming the car with a foam gun (wish i had a pressure washer
)
Car rinsed then washed panel by panel with foam gun and cleaning my wash mitt in a rinse bucket with grit guard
Rinsed again then car was dried using a metro blaster and cobra guzzler with qd spray
Car was then clayed using Speedy prep towel (also first time using, normally used either meguiars or mothers clay bar in the past)
This part gets kinda mixed up as i was just randomly taking pics in between polishing
Hood test spot ended up using wolfgang TSR on a white CCS pad
After one pass
I split the hood in half and corrected one side using wolfgang duo( TSR on white pad - Finishing glaze on Grey pad
Uncorrected
Corrected
50/50
Car was then dusted, and cleaned with Carpro eraser before applying WG fuzion
Final pics
Black Honda Fit



Started out with the rims

wolfgang wheel and tire cleaner, CG all clean + APC, and variety of brushes



Door jams, crevices and gas cap area cleaned using APC and detailing brush


Heavily soiled areas sprayed with APC and let to dwell for a bit before foaming the car with a foam gun (wish i had a pressure washer


Car rinsed then washed panel by panel with foam gun and cleaning my wash mitt in a rinse bucket with grit guard

Rinsed again then car was dried using a metro blaster and cobra guzzler with qd spray


Car was then clayed using Speedy prep towel (also first time using, normally used either meguiars or mothers clay bar in the past)

This part gets kinda mixed up as i was just randomly taking pics in between polishing
Hood test spot ended up using wolfgang TSR on a white CCS pad

After one pass

I split the hood in half and corrected one side using wolfgang duo( TSR on white pad - Finishing glaze on Grey pad
Uncorrected


Corrected


50/50




Car was then dusted, and cleaned with Carpro eraser before applying WG fuzion
Final pics




