Flyby 30

[skip62]

So I polished the windshield with DA and Ceriglass, wiped down with Eraser, then applied the Flyby 30 to one of the felt squares wrapped on a Carpro block in a criss-cross direction. Something doesn't seem right when applying. I would get about 3 swipes and would have to add more Flyby 30. It was evaporating almost immediately. None of the videos I watched did it dry up that quick. I kept going and did the whole windshield. It was 60° out, a little humid, and the car was in the garage before, during and after. I have not poured any water on it to see what happens yet. Is this what's supposed to happen?

Thanks,
chris

 

[Rsurfer]

It does flash quickly. Try using a round make-up cotton applicator and apply in a circular motion. You still need to work quickly. Also, use some tape to section off small areas, this will help you see where you left off. Flyby 30 flashes clear and is hard to see where you stopped and where to begin.

 

[jay_rap]

I also had some issues the other day with 30 flashing quickly this past weekend while I was applying it to my glass shower door. Does anyone know if it is a moisture cure product?

 

[skip62]

Great, thanks for the info. As long as I know it's normal, I'm ok with it. Appreciate the help.