Getting Natty's Blue Out of Jar

5

5Toes

New member
Joined
Jun 17, 2011
Messages
97
Reaction score
0
Hey All. I bought some Natty's Blue as my first ever wax product. Great stuff. BUT I have a problem.

On the same order, I also order the Lake Country CCS Euro applicators. Love those too. Just I cant get the wax on them at all! My first time suing the wax, I dropped the first two applicators, so I wasted a bunch of product having to use 3 applicators :(

Either way, I see Mike Phillips take wax out of the jar and rub it on the pads he uses. How can I do this. I have held the jar and knocked it a couple times,, but it wont budge out. Maybe Microwave for a couple secs then try to get it out?

Any help appreciated
 
You can do that or let it sit outside for a bit. You say you dropped some applicators and you wasted a bunch of product. You shouldn't have that much product at all on the pad..certainly not clumps of it.
 
I didnt have clumps. But it was very hard to get an even finish, had to scoop even amounts onto each end.
 
just put the pad on the wax and move the jar three or four times in a twist motion. It will heat the wax and melt it and it will be on your pad. You shouldn't notice that any is gone from the jar that's how little you need.
 
Once I get it out?

See the problem is that only the tip of the applicator fits in the jar. Therefore, only tip can be used to wax car
 
Use your fingers. Wipe some out, dig it out with your finger and then smear it lightly over the applicator. Or cut a chunk of wax out of the jar and wipe it over the applicator. Do it over a clean sheet of paper so if you drop anything, you don't have to throw it away.
 
get some microfibre gloves to hold the wax

maybe you can just pass the wax back and forth a few times, put it back in the jar, then wax your car using both hands!

or just take a butter knife and scrape off a thin amount to prime the pad. Once primed you need very little for subsequent applications
 
You must log in or register to reply here.
Back
Top