Giving Away Some Buffing Pads!

Status
Not open for further replies.
I like the Kompressor and Hydro's :xyxthumbs:
 
I like using the Orange "light cutting" - White "polishing" - and Blue "finishing" pads.
 
I like the 4" LC CCS pads for spot repair. Made my life much easier when I polished the scratches out.
 
i like all of them but the favorite is the orange one =]
those pads look good, and congratz to anyone who win ,cool collectables whith function =]
 
yellow, whites, and blues get the most use from me. I've tried CCS and Flats, but have yet to try Hydros. Crossing my fingers :D
 
Hydro-Tech 5.5" (flat) x 7/8" (thin). Deliver power well and easier to clean.

Those give-away HT pads are just so cute and festive!
 
My favorite LC pads are the 5.5" flat ones. I first started out using the 6.5" pads but I think that it was dragging the machine too much (especially the PC7424). I was inspired by Mike Phillip's thread on optimizing the PC7424 by using the 5.5" and I'm hooked!!! I also like them because it doesn't absorb and consequently waste product as much as the 6.5" pads. It's easier to use and clean as well.

Merry Christmas!
 
Those are cool!

Just got the HTs last week and they quickly became my favorite!
 
HT pads is all I use. I can always use a few more Crimson for dedicated LSP's.
 
HT polishing pads are my favorite, lots of use for the crimson. Just have to decide regular or low-profile.
 
Count me in!!! I have been wanting to try this out!!!
 
Without question, my favorite LC pads are the Hydrotech pads. They have better cut then their other pads and they finish down beautifully.
 
Status
Not open for further replies.
Back
Top