Guess what size Holley carburetor this is?

Well gosh darnit I got to the party too late! (Although I'd probably said 780).

I knew it wasn't a 650, they are typically spread bores. Best mileage when puttin' along with the teeny tiny primary and whoosh does it dump gas when those fist size secondaries open! :laughing:

I take it the carb is in this?

JimmyWithSlots003.jpg


Man does that body bring back memories! Back around 82 or so I had a 73 Blazer Silverado with all the bells-n-whistles. It *was* as spotless truck, brown metallic w/white inserts. Mostly stock w/small lift kit, HEI, headers, etc. and a set of gears.

Spent FIVE HOURS one morning after work (worked on the night crew back then) sitting in a mud hole, (well mostly a muddy water hole) with both axles 'high centered'.

Little did we know at the time that the tracks had been dynamited out and if you didn't have at least 38's you had no chance in he!! getting out of that sucker! I had muddy water 3"~4" deep inside the truck up till the point where we had a buddies dad with a farm tractor that came down and pulled us out. He backed down to my rear bumper while I crawled around in chest deep mud trying to hook chains over the rear axle. Then once it was hooked up he used the PTO to lift the rear end up and start yanking.

That darned tractor stood straight up in the air! The three guys that were with me ending up with two standing on each end of the front axle of the tractor, another one straddled the hood (along with his little brother) while the dad kept yanking till the Blazer started moving backwards. Picture in your mind all those guys on top of that old IH tractor and it bouncing up and down like a bronco bull..... :rolleyes:

Spent the next 3 days pulling the interior out piece by piece, door panels, all the trim except the area behind the back seat, (because it was above the waterline). Didn't try that again!!! :laughing:
 
New truck? What did you get???

1978 Chevy 3/4 Ton with 1-ton running gear.


New to me. Classic Chevy body lines, real steel construction. Leaf spring suspension. It's going to be big, bad and fast.

The most complicated component will be an HEI ignition. I like to keep everything simple so I can do all my own work.


Here's some before and after shots of some of the restoration work I've already done. It's time to move onto the engine and transmission.

Project78PavementPounder032.jpg


Project78PavementPounder033.jpg



Close-up...
Project78PavementPounder034.jpg






Project78PavementPounder048.JPG


Project78PavementPounder049.JPG



Dana 60 Front Disc Brakes with a brand new set of Warn Locking Hubs
Dana60withNewWarnHubs02.jpg




This is the kind of work I like to do when I'm not buffing out car...


:)
 
Mike,
Please maintain my admiration for my guru and tell me the white band around your upper radiator hose is of some significant value and not just the parts store upc tag!
All kidding aside, that's an awesome looking big-block. I haven't had that kind of torque in my driveway since my '73 Riviera. Had a '80 shortie 2WD pickup a few years ago that got its tired diesel swapped out in favor of a 350 Olds motor. It definitely earned an honorable mention for torque output, but pale in comparison to a real big block.

Bill
 
Those old Chevy trucks are fun. I miss the days when I had something with HEI and a 4 barrel instead of computers and FI. I had a 78 Blazer with a blown & juiced big block that did the coolest 4 wheel burnouts on 44" swampers.
 
Back
Top