Andr3wilson
New member
- May 16, 2012
- 1,615
- 0
Hey all!
So recently I have been asked and seen the question popping around asking if wheel cleaners are LSP safe.
So to help answer this question I got one of my winter rims, applied some wheel sealant, then hit it with CG Diablo straight dilution and Sonax Full Effect. I know there are a ton of different wheel cleaners out there. I chose Diablo and Sonax because of there popularity, and the fact that Diablo is known as gentle, and Sonax is known as a stronger cleaner.
I am testing my two wheel LSPs. CG Wheel Guard and SV Autobahn. I understand there are more out there, and you can use normal wax and sealant on your rims, but I am choosing these ones.
To set up the rim. I washed it with CG Wash&Gloss, then wiped it down with Carpro Eraser before sealing. I broke it off into 4 sections. 2 sections (one for each LSP) for Sonax and 2 sections for diablo.
I applied both LSPs to manufacturer directions and let them cure for a few hours
Beading test. Spraying on pure water.
Autobahn
Wheel Guard
Blank control
Sonax
Now to get around the Diablo dilution, I put it on straight.
I let them both sit for around 10 mins before rinsing them off. Dried the rim, and liberally applied a few sprays of water.
Diablo After
Sonax After
Control
So to conclude, I will have to say that in this case both Wheel Guard and Autobahn withstood the Sonax and the Diablo in a sense. I noticed in the rinse phase, Autobahn was still sheeting off the water much on the Diablo side than the Sonax side.
I also noticed that the Sonax side had "looser" beading than the Diablo. This applies to both Wheel Guard and Autobahn. I also found that the Diablo side LSPs still had a slight slickness to them whereas the Sonax didn't after drying.
Now I believe after another 1-2 hits of Sonax, the LSP would be removed, and 4-6 hits of straight Diablo would take off the LSP. So to conclude, a well coated rim can be washed with a light dilution of Diablo without removing any LSP (heat and brake dust will be more harsh than Diablo). I personally use normal car wash soap in a foam cannon with an assortment of brushes on my rims. The sealant makes cleaning a breeze!
Thanks for reading and hope this answers some burning questions! :dblthumb2:
So recently I have been asked and seen the question popping around asking if wheel cleaners are LSP safe.
So to help answer this question I got one of my winter rims, applied some wheel sealant, then hit it with CG Diablo straight dilution and Sonax Full Effect. I know there are a ton of different wheel cleaners out there. I chose Diablo and Sonax because of there popularity, and the fact that Diablo is known as gentle, and Sonax is known as a stronger cleaner.
I am testing my two wheel LSPs. CG Wheel Guard and SV Autobahn. I understand there are more out there, and you can use normal wax and sealant on your rims, but I am choosing these ones.
To set up the rim. I washed it with CG Wash&Gloss, then wiped it down with Carpro Eraser before sealing. I broke it off into 4 sections. 2 sections (one for each LSP) for Sonax and 2 sections for diablo.
I applied both LSPs to manufacturer directions and let them cure for a few hours
Beading test. Spraying on pure water.
Autobahn
Wheel Guard
Blank control
Sonax
Now to get around the Diablo dilution, I put it on straight.
I let them both sit for around 10 mins before rinsing them off. Dried the rim, and liberally applied a few sprays of water.
Diablo After
Sonax After
Control
So to conclude, I will have to say that in this case both Wheel Guard and Autobahn withstood the Sonax and the Diablo in a sense. I noticed in the rinse phase, Autobahn was still sheeting off the water much on the Diablo side than the Sonax side.
I also noticed that the Sonax side had "looser" beading than the Diablo. This applies to both Wheel Guard and Autobahn. I also found that the Diablo side LSPs still had a slight slickness to them whereas the Sonax didn't after drying.
Now I believe after another 1-2 hits of Sonax, the LSP would be removed, and 4-6 hits of straight Diablo would take off the LSP. So to conclude, a well coated rim can be washed with a light dilution of Diablo without removing any LSP (heat and brake dust will be more harsh than Diablo). I personally use normal car wash soap in a foam cannon with an assortment of brushes on my rims. The sealant makes cleaning a breeze!
Thanks for reading and hope this answers some burning questions! :dblthumb2: