Need advice...Foam Guns

Salsfirst said:
I'm using this same foam gun, however, the piece that adjusts the amount of mixture just slides around. Can't get it to stay put. Am I doing something wrong?
Click to expand...
There's a screw on top of the soap dilution valve. Make sure to turn it tight to the right.
 
I use the same gun and same wash even and I cant get my foam to look that good. I have it set 2 from the lowest water setting. How much wash are you adding? I usually just go with the 2oz.
 
gatoman39 said:
There's a screw on top of the soap dilution valve. Make sure to turn it tight to the right.
Click to expand...

Mmm, I did that but it doesn't seem to be long enough to get down to tighten it. Could they have put on the wrong screw? It is the same size as the one on the sliding soap dispensing thing.
 
My foam master is actually "hot and cold", for some reason Ill get good thick foam and then all of a sudden not. Yes there is soap in it :)

I thought it was the screw at the top but I have it tightened down and its not making any difference.

Ive NEVER had the screw in the end of the sliding dispenser thing, and everything has always worked fine so Im not sure why its there (it wasnt installed from the factory either, just kinda rolling around in the box when I got it)
 
I have the foam gun. I get a good foam soap on it. after that I wash with the bucket method. I got a black car and noticed that there is soap scum marks like soap spots. I am thinking it is not the foam gun but the shampoo I put in the bucket might be too much. I had this same problem before I figured out the right ratio of my old soap.
 
Why is the AG foam gun costs twice as the Gilmore gun,if they are basically the same thing ?
 
You must log in or register to reply here.
Back
Top