Avgguy
New member
- Jul 5, 2015
- 185
- 0
I don't mean to hijack this thread, but since it already exists and I have sort of the same question - I thought I'd ask about 303 here as well.
I recently cleaned my interior with a Woolite+distilled mix (only on the leather parts, and some vinyl probably because I cannot tell the difference), followed by Meg's Quik Interior and Aerospace 303 Matte on all surfaces (I didn't but the 303 on my nav screen because I'm scared - apparently the one in 2IS Lexus' are delicate)...
I applied it to a cloth, then wiped the surfaces, then followed it up with a clean dry cloth. That was sometime last week. I haven't driven much lately, but when I have, I notice my hands feel slippery after touching most of these surfaces. I don't see ANY streaks, and the car is no more shiny than it was before - (it was pretty matte before, and it looks the same, just cleaner) - but my hands are slippery as hell.
Did I not wipe away enough? Should I buff it?
Also, I have a really bad tendency to push my door open with my foot, which causes light scuff marks on the lower panel. I cleaned them with Meg's QID then followed up with the 303 - and I see MORE scuff marks than before. I can provide a photo if it helps. They aren't scratches, just lines, mostly from my Chucks (so, rubber, no sharp edges). Is it because 303 is matte that its causing them to be more visible?
I wish I could help but I have always used the 303 wipes and have been careful to 1) use enough but not use a REALLY LARGE amount and 2) to buff it completely dry, as it won't air dry itself.