Need Help With Sand Paper Flap Wheel

S

StaySolitude

New member
Joined
Oct 9, 2011
Messages
3
Reaction score
0
I am trying to design a car wash type system that will allow a linear actuator to run a 1ftX1ft stainless steel case through a series of sand paper flap wheels. There will be two shafts with up to 50lbs on them.

I need to spec a motor to run these two shafts using a pully/v-belt setup. Does anyone know what kind of AC motor I should be looking for? The wheels are 3 inches wide and 6 inches in diameter. They are speced for 6000 rpm but doesn't this seem way to high? I have heard buffing stainless steel only requires around 150 rpm.

Any suggestions?
 
StaySolitude said:
I am trying to design a car wash type system that will allow a linear actuator to run a 1ftX1ft stainless steel case through a series of sand paper flap wheels. There will be two shafts with up to 50lbs on them.

I need to spec a motor to run these two shafts using a pully/v-belt setup. Does anyone know what kind of AC motor I should be looking for? The wheels are 3 inches wide and 6 inches in diameter. They are speced for 6000 rpm but doesn't this seem way to high? I have heard buffing stainless steel only requires around 150 rpm.

Any suggestions?
Click to expand...

^^^^:dunno:
 
My answer now is the same as it was the last time you made a thread here:

http://www.autogeekonline.net/forum...ed-polisher/41922-stainless-steel-buffer.html

For an automated process like that you're probably looking for industrial-grade machinery along the same lines as a CNC machine; I would suggest looking to a supplier of that sort of equipment for guidance.

A detailing forum like this isn't really going to be able to help much if you're not looking for manual polishing/buffing techniques.
Click to expand...
 
I am simply looking for the suggested rpm to run a sand paper flap wheel 3" wide and 6" in diameter to polish stainless steel
 
You must log in or register to reply here.
Back
Top