New DA Polisher

[Critical]

Used the "Search function" for advice, but didn't find any topics relating so here's my question.

I've detailed for years using "used polisher's"

I just ordered my first "new" polisher G110v2 from AG of course.
Was just wondering if there is a proper technique to break a new polisher motor in?

I've read to first run it on the slow speed for a few minutes to set the polisher, any other techniques or should that take car of it.

Thanks in advance.

 

[SonOfOC]

Not necessary. Use right of the box.

 

[Rsurfer]

Set it on speed 6 and go for it.

Used the "Search function" for advice, but didn't find any topics relating so here's my question.

I've detailed for years using "used polisher's"

I just ordered my first "new" polisher G110v2 from AG of course.
Was just wondering if there is a proper technique to break a new polisher motor in?

I've read to first run it on the slow speed for a few minutes to set the polisher, any other techniques or should that take car of it.

Thanks in advance.

 

[Old Tiger]

Set it on speed 6 and go for it.

Or get the Megs DA MF and set it to Speed 4!

 

[mark58]

As with any motor with brushes you should not run it under load or full speed for few minutes. I would suggest to run it at speed 1 or 2 for few minutes to make sure brushes are seated.

 

[Critical]

As with any motor with brushes you should not run it under load or full speed for few minutes. I would suggest to run it at speed 1 or 2 for few minutes to make sure brushes are seated.

This is what I've heard several times, and i will do this just to be sure!

thanks