Not sure what to do after applying WG TSR ?

C

clnimck

New member
Joined
Sep 11, 2014
Messages
24
Reaction score
0
Hi Everyone,

I applied the wolfgang Total swirl Remover yesterday for first time. It got dark and I was not able to do the following steps.

Wofgang Finish Glaze followed with Wolfgang Deep Gloss Sealant, followed then with Fuzion.

The problem now is it rained today and my question is I am busy at work and will not be able to continue the process until Saturday. Since now it will be three days since I applied WG TSR, would it be okay to just was the car with WG Auto Bathe, then apply Wolfgang Finish Glaze, followed with applying WG Deep Gloss Sealant, then followed with applying WG Fuzion.

The other option I was thinking wash it WG Auto Bathe, then apply WG Polish Paint Enhancer, then followed with applying WG Finish Glaze, then followed with applying
WG Deep Gloss Paint sealant, then followed with applying WG Fuzion.


Looking for advise and I thank you in advance for your help

Thanks!!!
Chris
 
You should just wash it and continue with the next step (the Finishing Glaze). If was just rain on it, you could use a waterless wash if you have it rather than the 2 bucket wash.
 
Thank you all for your advise!!! I can't wait till tomorrow to get this done.
 
considering you did not drive the car, I personally would use a waterless wash a panel at a time to make sure its surgically clean. then go about finishing your polish session.

I hate washing cars. It seems to take me forever no matter how much I try to limit the amount of tools and steps used.
 
Regardless of your wash method, it sounds like it was outside and i would need to wash it again...whether full on 2 BM or rinseless...to make sure the paint is clean again. Then i would, as others have suggested, just pick up with whatever was next in your process.
 
You must log in or register to reply here.
Back
Top