- Thread starter
- #21
Thanks for the response Derrick.
I used 50/50 IPA mix to clean after each attempt. I never went about 2.5 on the 3403 which is about 1700 RPM's I think. I'm going to get a temp gauge tomorrow on sale.
Any idea of the max temp a paint should get while you're polishing. I know it's probably dictated by type of paint. This paint was a MB door. Probably a 200x model. Today, I finally got the finish right as far as I can tell. No micro marring, swirls etc on the finishing stage. My best results were with a CCS white pad.
I used 50/50 IPA mix to clean after each attempt. I never went about 2.5 on the 3403 which is about 1700 RPM's I think. I'm going to get a temp gauge tomorrow on sale.
Any idea of the max temp a paint should get while you're polishing. I know it's probably dictated by type of paint. This paint was a MB door. Probably a 200x model. Today, I finally got the finish right as far as I can tell. No micro marring, swirls etc on the finishing stage. My best results were with a CCS white pad.