HighEndDetail
New member
- Apr 29, 2006
- 1,881
- 0
This was a referral from someone I did on anther site. The owner of the company called and said he needed his wife's RR done. I arrived on site at 10 after 10 in the morning. I had some traffic here on 285 in atl. . I should have been there at 9:45
And I forgot my ladder. So I felt like I was Justin climbing all over this thing
Interior
Vac with ridgid, leather was cleaned with a half side target brand magic eraser and woolite/water mix. Protected with PB Leather Stuff. And it was also used on the door panels
I didn't have my new DP Interior Surface Protectant
at the time.
Exterior Washed with OP car wash, and then clayed.
Tires/wheels
Pre sprayed with PB apc/water mix then washed with Op car wash and a '16 deep reach wheel brush, and a reg wheel brush. Tires and wells, were treated with AA tire foam while wet.
Exterior Protection Shine
Pinnacle Liq. souveran, just a dime size applied to foam pad by hand per panel. A little bit goes a long way. Then spritzed with crystal mist to remove any dust.


Interior
Vac with ridgid, leather was cleaned with a half side target brand magic eraser and woolite/water mix. Protected with PB Leather Stuff. And it was also used on the door panels
I didn't have my new DP Interior Surface Protectant

Exterior Washed with OP car wash, and then clayed.
Tires/wheels
Pre sprayed with PB apc/water mix then washed with Op car wash and a '16 deep reach wheel brush, and a reg wheel brush. Tires and wells, were treated with AA tire foam while wet.
Exterior Protection Shine
Pinnacle Liq. souveran, just a dime size applied to foam pad by hand per panel. A little bit goes a long way. Then spritzed with crystal mist to remove any dust.









Last edited: