sealeant with easy removal

[akimel]

Would it be fair to say that just about all the synthetic sealants that AugoGeek sells are easy to remove, the one exception perhaps being Klasse High Gloss Sealant?

Finish Kare 1000p has not yet been mentioned, so I'll throw it into the mix as well. Once it hazes, I have found it very easy to buff off. If durability is a decisive concern, this is the sealant I would choose.

 

[Joe in PA]

Another vote for BlackFire Wet Diamond. :dblthumb2:

 

[1flyfisher]

KLASSE SEALANT GLAZE.
This product gets a bad rap as far as I am concerned. Yesterday I did an entire van with it (once again) and the stuff comes off better than anything I have ever used. I don't get the complaints about it. Obviously they are putting on too much or doing something wrong. Plus it is the best protectant sealant . tough as nails. I use a wheelchair and apply it with a sponge mop with a microfiber bonnet over it for the high up walls of my 2010 GMC Savana. I then remove it from high up areas with a nice micro fiber towel bungeed over a microfiber wash brush with a telescoping handle (the one they sell at walmart. It comes right off for me.

 

[1986mustanggt]

KLASSE SEALANT GLAZE.
This product gets a bad rap as far as I am concerned. Yesterday I did an entire van with it (once again) and the stuff comes off better than anything I have ever used. I don't get the complaints about it. Obviously they are putting on too much or doing something wrong. Plus it is the best protectant sealant . tough as nails. I use a wheelchair and apply it with a sponge mop with a microfiber bonnet over it for the high up walls of my 2010 GMC Savana. I then remove it from high up areas with a nice micro fiber towel bungeed over a microfiber wash brush with a telescoping handle (the one they sell at walmart. It comes right off for me.

I agree. I have use Klasse SG without any of the issues mentioned by some users and it looks great. WG sealant is very easy to use as well as Poorboys EX-P. The key to an easy product and I have noticed this with any product, DO NOT put a lot on, it is a waste of product and energy. Good luck with your decision.

If you want to try WG let me know I can send you some.

 

[Rsurfer]

The two flavor of the month are CQuartz and GTechniq. GTechniq is said to last 2 years.

 

[1flyfisher]

Yeah I continually read on this website people complaining about KSG. I did an entire van with it from my wheelchair yesterday and the stuff came off better than anything I have ever used. I think it comes off easier than KAIO which people always seem to say comes off very easy. Trust me if it didn't come off easy I would not use it. The stuff just wipes on and wipes off.

I recommend a clean microfiber towel to wipe it right off. I mean a clean towel that doesn't have any build up of KAIO on it or anything else you might be buffing off first. I got those thick nice blue ones I think from target. I think they are viking, they are blue on one side and gray on the other.
Maybe I am doing something others aren't?
I am using those light blue microfiber pads that you get at walmart. I have the Meg's clay kit that came with the detail spray that comes in the red bottle. I spray 3-4 sprays on the pad to moisten it and then I do a circular swirl like this @ on the mf pad to get some KSG on and into the pad. I do a Large area with that amount, almost my entire cargo door. Then I just add about a nickle/dime sized drop as I go along and start a new area. 2-3 small drops I can do the entire hood of my van. You have to let it dry a little. maybe that is folks problem. I start on one spot on my van and by the time I am done doing the whole van I take a little break. Drink a soda. Then do some plastic trim and then I come back and buff it off. It wipes right off for me. Maybe You need to let it sit for a half hour or or so.

People must be globbing it on that have trouble getting it off.

I imagine there are waxes and sealants other than KAIO/KSG that might give you a different type shine or a better shine if that is what you want. I am happy with the shine for me as this is an off road van that sits outside and is a DD and I am after long lasting protection from dirt, dust, mud, salt etc. My van is silver by the way. You just can't beat the Klasse twins for long lasting protection. I also bought a can of Finish Care fk-1000P that I have yet to try. I bought it because I heard it is very long lasting and goes on and off easy. I haven't gotten around to it because the Klasse twins work so well.

I agree. I have use Klasse SG without any of the issues
by some users and it looks great.

 

[dougaross]

Yeah I continually read on this website people complaining about KSG. I did an entire van with it from my wheelchair yesterday and the stuff came off better than anything I have ever used. I think it comes off easier than KAIO which people always seem to say comes off very easy. Trust me if it didn't come off easy I would not use it. The stuff just wipes on and wipes off.

I recommend a clean microfiber towel to wipe it right off. I mean a clean towel that doesn't have any build up of KAIO on it or anything else you might be buffing off first. I got those thick nice blue ones I think from target. I think they are viking, they are blue on one side and gray on the other.
Maybe I am doing something others aren't?
I am using those light blue microfiber pads that you get at walmart. I have the Meg's clay kit that came with the detail spray that comes in the red bottle. I spray 3-4 sprays on the pad to moisten it and then I do a circular swirl like this @ on the mf pad to get some KSG on and into the pad. I do a Large area with that amount, almost my entire cargo door. Then I just add about a nickle/dime sized drop as I go along and start a new area. 2-3 small drops I can do the entire hood of my van. You have to let it dry a little. maybe that is folks problem. I start on one spot on my van and by the time I am done doing the whole van I take a little break. Drink a soda. Then do some plastic trim and then I come back and buff it off. It wipes right off for me. You need to let it sit for a half or or so.

People must be globbing it on that have trouble getting it off.

I imagine there are waxes and sealants instead of KAIO/KSG that might give you a better shine if that is what you want. I am happy with the shine for me as this is an off road van that sits outside and is a DD and I am after long lasting protection from dirt, dust, mud, salt etc. You just can't beat the Klasse twins for long lasting protection. I also bought a can of Finish Care fk-1000P that I have yet to try. I bought it because I heard it is very long lasting and goes on and off easy. I haven't gotten around to it because the Klasse twins work so well.

Since this thread about sealant with easy removal why does it take a paragraph to describe the process. I mention 3M Performance Finish above. The process - wipe on a 2'x2' area, no waiting, wipe off. Now that's what I call EASY.

 

[1flyfisher]

Lol, because that is what I decided to write.

Since this thread about sealant with easy removal why does it take a paragraph to describe the process. I mention 3M Performance Finish above. The process - wipe on a 2'x2' area, no waiting, wipe off. Now that's what I call EASY.

 

[Frank A.]

Another vote for Ultima Paint Guard Plus. Wipe it on and that's it. 10 minutes to do the whole care. It leaves a great shine and beads water like crazy. Good luck!

Regards,
Frank A.

 

[Rsurfer]

Another vote for Ultima Paint Guard Plus. Wipe it on and that's it. 10 minutes to do the whole care. It leaves a great shine and beads water like crazy. Good luck!

Regards,
Frank A.

UPGP doesn't qualify to the op's question cause you don't wipe it off.Im the MAN

 

[onlycodered]

Out of the sealants that I've tried so far I think Blackfire Wet Diamond is the best when it comes to how easy it is to remove and how wet it makes your car look.

 

[WEST SIDE]

I agree. I have use Klasse SG without any of the issues mentioned by some users and it looks great. WG sealant is very easy to use as well as Poorboys EX-P. The key to an easy product and I have noticed this with any product, DO NOT put a lot on, it is a waste of product and energy. Good luck with your decision.

Another vote for Klasse twins or WGDGPS3.0,i just did my T-Bird with DGPS and the wifes DD with the twins as stated before don't use too much and make sure both the paint and wiping cloths are clean.

 

[ScottB]

Try DP Policoat (on BOGO now) or UPP from Four Star and you'll be amazed at outcome and look and feel too.

 

[RandyD]

My experience - Easiest to remove is Poor Boys EX-P 2nd easiest is Blackfire wet Diamond.

 

[molarman]

wg 3.0 is very easy to apply and even easier to remove, as it also seems to last quite a while here in dallas, in the summer heat. just remember to apply a THIN layer, it doesnt take much.

 

[CEE DOG]

My experience - Easiest to remove is Poor Boys EX-P 2nd easiest is Blackfire wet Diamond.

When it comes to ease of use the WGDGPS is easier then BFWD. BFWD looks really great and is easy to remove but it's finicky on the length of time it sits on the paint, little bit of dust, and sweating issues the next day or two.