Bus_Driver
New member
- Nov 18, 2012
- 71
- 0
2002 Chevy Silverado. On the top of a few trim pieces, it has some type of contaminant that has been very difficult to remove. If I had to guess, it seems like shipping tape/film used for scratch protection, that was left on for years and was melted by outside exposure. I don't know the history, because it is a friend's truck that she got from her father after he passed away.
I've tried:
Griots Clay. It was no match. Clay pieces stuck to the trim.
Nanoskin pad. Almost ruined the pad.
Pinnacle paintwork cleansing lotion with a mf applicator.
FG 400 with an mf applicator.
APC+ D103 and let dwell for a minute and brush with a nylon brush.
wet sanding with sanding pads that come with headlight restore kit.
The APC and wet sanding combo seemed to do the best, but it would take me a couple of hours to do a 1 foot section, and not completely sure I would be able to remove all of it.
How long can I let the APC dwell on the paint?
Anything else I should try?
I've tried:
Griots Clay. It was no match. Clay pieces stuck to the trim.
Nanoskin pad. Almost ruined the pad.
Pinnacle paintwork cleansing lotion with a mf applicator.
FG 400 with an mf applicator.
APC+ D103 and let dwell for a minute and brush with a nylon brush.
wet sanding with sanding pads that come with headlight restore kit.
The APC and wet sanding combo seemed to do the best, but it would take me a couple of hours to do a 1 foot section, and not completely sure I would be able to remove all of it.
How long can I let the APC dwell on the paint?
Anything else I should try?