sweatthedetails
Member
- May 15, 2012
- 483
- 0
Hi geekers. My last detail i noticed when my Flex spooled up or down it would make a strangled, high pitch whinning noise. I detail part time and have tons of hours on this machine with no problems, even with the noise the machine worked like a champ. I do use the LC backing plates and at the time had the largest one on. I checked the snuggness of the retaining bolt, it was fine. I then removed the plate, the teeth are good, i relubed the felt. While the plate was off I pushed the trigger and the noise was still apprent and it seems to be coming from the motor its self. Im a helicopter mechanic by trade and have no problem taking this bad boy apart to find out whats going on. Has any one else had this issue?