So i had this idea tonight for when i get home..
To start the decon i'm going to contact wash with labocosmetica's purifica and then follow up with purifica cut 1:10 in a spray bottle for a clay lube with the clay scrubber.
What do you guys think?! I have a LOT of waterspots.
I will probably do a quick rinselss first not sure if it will interfer with the chemistry of purifica so to be safe i will rinse the rinseless haha!
Note this is on their Data Sheet:#
PURÌFICA shampoo is very versatile and can be used in different concentrations. For maintenance washes and to clean surfaces protected with Nano Coating, dilute 1:200 and apply with a glove.
For gritty rain, with a lot of mineral residue, or if the car has been left out in the snow, always use as a diluted post-coating maintenance shampoo or as a pre-wash diluted 1:100, letting it set for around 4 minutes, without allowing it to dry out, and rinse.
For more severe situations, apply a1:10 #PURÌFICA solution to the wash pad. When used with the 3pH® technique, in the first phase, #PURÌFICA can be diluted 1:4 and sprayed with a foam gun.
To eliminate the most noticeable limescale contamination: dilute #PURÌFICA 1:10, spray it on the surface and also on glove or the brush; recommended for the areas with the heaviest contamination, like chrome vehicle emblems and lettering and the plastic around the windscreen wipers, to remove deeper contamination. For stubborn spots, heavy limescale contamination or mineral deposits, like rust, and cement spots, we recommend using #ÈNERGO
I have to say Labocosmetica must have the most detailed site in the industry for ways to use their products.
