Which Glaze?

Billd0957

Billd0957

New member
Joined
May 14, 2009
Messages
80
Reaction score
0
I have a Black STS and I want a DEEPER wet look. At this time I have Fuzion in my shopping basket (BOGO) but I want to make sure I can use it. I also still have a few small swirls I need to get out.
This is what I have done to the car
XMT Swirl remover #2
XMT Swirl remover #1
Meg NXT

Should I glaze the car? If so which glaze
Will Fuzion go over the NXT?
Can I use NXT Detail spray over the Fuzion?

I know these are a loot of ? but I always get good advice from this site.
 
So do you think it would be OK to

Glaze (to remove NXT)

Apply Fuzion wax

What should I use to maintain the Fuzion wax shine?
 
Keep your existing coat of Meguiar's NXT and just apply a coat of Wolfgang Fuzion on top of it. Fuzion can go on top of NXT. Use Wolfgang Instant Detail Spritz or Wolfgang Deep Gloss Spray Sealant to maintain the shine of Fuzion.
 
Fuzion is a wax and will work with any glaze, usually Megs 7 and RMG are most often suggested. If using a sealant move to the Poorboys Offering. Most should remember the Wolfgang 3.0 Finishing Glaze is not truly a glaze, but a finishing polish like Nano from Menzerna.
 
Thank You All

PB Black Hole Glaze with A few coats of Fuzion it is.:cheers:
 
There are only 2 glazes I use, Danase Wet Glaze and Prima Amigo. Amigo will remove the NXT you have on the car. I would look into Meg 105 or Menz SIP to help remove your swirls then a good finishing polish like 205 or 106fa
 
I'll agree with Sal on the two glazes. I use Danase Wet Glaze alot. Very easy to use, and it bonds to carnauba as well as sealants and has no cleaners. In fact, you can apply it over carnauba and then go to a sealant if you wish.
 
I finally had time to finish the car, here are the pics

:buffing:
 
You must log in or register to reply here.
Back
Top