will household softened water spot?

builthatch

New member
Joined
May 25, 2008
Messages
2,352
Reaction score
0
i'm just curious what others experiences are since this thread popped up-

http://www.autogeekonline.net/forum/auto-detailing-forum/15782-waterspots-atop-opti-seal.html

i've always been under the impression that it was helping me to use the custom interface setup i have in my garage that is hooked up to the softened household water. i have a hot and cold outlet that are both connected to a mixer to control the temp of the supply to my hose.

i have a system like this one, with a tank like the one in the middle

DED1EB60C2.jpg
 
usually spotting is the minerals in the water, and softners to my knowledge do not remove minerals.
 
Mine does! It aggravates the hell out of me. I need a in-line filter in the garage. I guess it is better than hard water.
 
I have well water, so we have a softener. It certainly makes a big difference, as the ground water is quite hard down here. No comparison. Even if I was on city water, I'd probably still use a softener & carbon filter as most municipal water supplies seem to be chlorinated and hard (barely any suds while lathering up during a shower, for instance). I hate traveling and being at hotels where your skin feels like rubber after a shower. Yuck! Obviously, that's no good for car washing.
 
usually spotting is the minerals in the water, and softners to my knowledge do not remove minerals.
I'm not an expert, but yes the salt minerals are still there in the softened water, however, it is a considerable improvement over non-treated water as there is certainly less scale as the water evaporates.
 
For more information see the “Water Filtration” article; one of a collection of detailing articles I’ve written for DetailingWiki; a series of informative, knowledge based, unbiased articles dedicated to automotive detailing
 
I occasionally use an inline filter on the hose when doing a very thorough detail
 
Back
Top