Recent content by 82Gman

Hi, I had Nanoskin Megatrend professionally installed about 18 months ago. It has been incredible, no swirls or marring, and I just rinse and spray a reload. Recently however, I got a sap shower from a tree in a parking lot. Used Nanoskin fine wash mitt and Chemical guys clay lube, lots of lube...

I've searched the forum, but can't seem to find this question. I have a 2013 Audi A7, it has a few chips on the hood, but I am ok with that. My question is; Will it affect a paint coating in a negative way. I just want to protect the rest of the paint. i was thinking of going with GTechniq EXO...

I searched the forum and couldn't find anyone dealing with paint correcting factory sealant. I've had 2 cars in the past month that were sealed at the dealership or factory. The coating is harder than anything I've ever encountered. 1st was a 2013 camero, red. 2nd was a 2012 Audi A8L, silver...

They are still on my camera. This car was going to be my ultimate restore. It was BAD. I thought it was charcoal gray and the wheels were gold. Its Nighthawk Black and chrome wheels.

Thanks for all the great feedback! I only went to the 105 with a microfiber pad, because I had hit it with a orange hex logic, V34 and the PC. The etching from the bird dropping was still very evident, but I couldn't feel it when I went over it with my finger. Looks like a thickness gauge is...

Yea at first I thought it was just the 105 being funky, when it grew, I knew it was jacked. Why there though? I used that combo on a couple of other spots and no problems. Oh well. Any ideas how I can prevent that from happening in the future? A paint thickness gauge maybe? Thank God it wasn't...

Yes it did

Hey, I'm willing to accept that! This thing made me a little gun shy.

My bad. It was a meguiar's microfiber cutting pad! It wasn't hot, so not burned, I think it actually just cut through.

Amen to that!

I feel like throwing up. Good thing I own this car. Time for a paint thickness gauge! M105 is a real b---- to work with. Seems to have a big learning curve. I had a couple of other spots that came out great. I was actually just trying to get the leftover M105 off and BAM. It came off ok, with...

I was restoring a badly neglected 2006 Acura RSX, NHB. While trying to remove a bird poop stain I switch to a Meguiar's Foam cutting pad and M105 on a PC. I went too far. See the attached pic. It's never been polished before, so I thought I was safe. Am I going to have to have it repainted?

I am looking for an option for my clients, as far as a coating goes. How would I become an authorized installer for Opti-coat?

Will Opti-coat adhere to single stage paint? No clear coat.

Never mind. I found the thread.