Recent content by Bigbwb

It’s just plastic. There are stickers near it which are obvious. No wrap.

Gotcha! My bad:). I’ll ask.

I didn’t bring it up to the dealer being I assumed a light buffing would fix it. It wasn’t horrible and when I started it sadly got worse. I may just buy the replacement pieces. I just don’t see it getting any better unfortunately.

No worries. It was cheap. This plastic must be super soft. I took a really soft foam sponge with a dab of 3D one and barely put any pressure on as a tried it on a tiny portion and the same thing happened. So will the speed and a new pad really make a difference or try the menzerna?

The plastx didn’t work, tried that first. It leaves the haze/dull look. So I’m guessing I need more of a polish without any cut?

Update! Tried the 3D one with a new black pad. Same issue. The gloss won’t return. Ughh!

Im near Milwaukee:) I didn’t realize plastx was that aggressive. Ok, I’ll order the 3D one (don’t need the sealant)if you think that’s best! I really appreciate the feedback! Plan to ceramic coatings afterward.

I should have asked if it’s worth trying the Meguiars plastx with the new finishing pads before I buy another product? Also, what speed on the portal cable orbital?

Great! I will try a new pad and a different polish.

Thanks guys. Ya, it was a white pad I think. Should I use a black one? I can try the 3d speed. Im assuming I need just a polish without abrasives?? Do you all feel confident I can remove the haze/cloudiness?

Hey folks, I just bought a new Yamaha YXZ1000 Side x side utv. It has very glossy blue plastic (not painted). It came from the dealer new however had some scratches. I consider myself pretty well versed in detailing and polishing cars having done many over the years and even ceramic coatings...

Thanks guys! I will try a lower dilution and perhaps skip the presoak unless it’s quite dirty (winter months). I think a panel at a time will help too.

I didn’t see that. I wonder if I could prespray one panel at a time though…then dry?

Hey guys, just recently switched from ONR to the Wolfgang si02. My technique is using one ounce in a gallon or two of water for the wash mitts and I also have diluted solution in a pump sprayer in which I pre spray the entire car before I start. Well anyway, I follow the dilution ratios pretty...

got it! Will do, thanks!