Recent content by dpevans

  1. D

    Low gloss ceramic

    Getting my Riverside Blue 2SS 1LE and though I have ceramic and graphene my cars in the past for this one I would like to try going with a low gloss ceramic, I don't want the shine I almost want a flat look. The hood will have matte PPF over the flat hood so I will be using a matte ceramic for...
  2. D

    Microfibre drying cloths lose their ability?

    You're addicted, good job. Does the wife know?
  3. D

    today I started the process of detailing my wife's car

    I don't think the lake county blue pad is for cutting and correction so 5 would be a bit fast on the PC. I use a PC and I cut on 5 or 6 and polish on 3-4. I also use 4 pads when I do my car.
  4. D

    Ceramic coating suggestions

    So let me rephrase that, well into my second year the Graphene is holding up well but it's neither here nor there.
  5. D

    Remove exhaust black stain

    Marine 31 Gel Coat Heavy-Cut Cleaner Wax, best boat cleaner wax, gel coat cleaner wax
  6. D

    Ceramic coating suggestions

    Your question is like asking what is your favorite color/brand of underwear, I personally like the easy of use of Ethos Graphene cause I can do it in my garage on a warm day, I am two years in with no visible signs of deterioration. I had Adams and Renny Doyle professionally applied and they...
  7. D

    Remove exhaust black stain

    I would start with clay and then a gel coat cleaner wax.
  8. D

    amateur paint correction help

    With my PC I have found a Microfiber cutting pad is a good place to start and I like the D30016, 90% of the time it gets most of the defects out and if I want to get more out I step up to a yellow or orange pad have used 3D cutting, M105 and they both work well. Then I hit the entire car with...
  9. D

    Black plastic trim

    Two thumbs up for GTechniq C4.
  10. D

    An argument with a detailer

    a sponge? I would never trust anyone with a sponge.
  11. D

    Ceramic coating on lights - First time experience

    Don't feel bad about taking 25 hours. That's about what it takes me to do a full correction. Wash and inspection, Tar and bug remover, Iron X, Clay, Wash and dry, Then I hit it with Yellow pad and whatever is needed to get major swirls out where needed, then I hit it with micro fiber pad and...
  12. D

    Overwhelmed With Options (New Car Protection)

    If you plan on taking off road I would suggest PPF on the bottom once you decide how to proceed with paint protection. Do the PPF after correction but before protection application.
  13. D

    Crazy lottery jackpots.

    It's my understanding that you DON'T sign the ticket, lock it in a safe and see a lawyer. If you don't sign it then the lottery has no right to disclose who you are and the lawyer can set up a trust. Then it stays all under the radar until you tell someone with loose lips you won.
  14. D

    Do stones "bounce off" PPF, and not leave a mark?

    I had the factory PPF on rear quarter panels and had installed PPF on the front bumper and front hood area. I have no chips after 4 years but I don't do a lot of highway driving. You are more likely to get stone chips from highways then in city. I did pull off the factory PPF just last summer...
  15. D

    Where not to spray iron remover on exterior?

    Never had an issue with CarPro IronX staining. I don't spray directly on to glass rubber or plastic and I make sure I rinse throughly behind all trim and my next step is always a thorough wash.
Back
Top