Anyone used LC Flat and Hydro-Tech cutting pads??

W

WRAPT C5Z06

New member
Joined
Nov 12, 2009
Messages
12,615
Reaction score
0
Does the cyan (blue) Hydro Tech have noticeably more cutting power than the LC FLAT orange, or vice versa?
 
07 z-oh-6 said:
Does the cyan (blue) Hydro Tech have noticeably more cutting power than the LC FLAT orange, or vice versa?
Click to expand...
I love my tangerine and my cyan pads.
The cyan pads have a good bite, and finish great.
The tangerine like the cyan stays pretty firm and also has some good cutting for minor swirls.
I found both pads to achieve any desired results depending upon the compound/polish you use.
These pads have become my favorite pads. That's all I use for my Flex. I love them!
 
Z06-Goose said:
I love my tangerine and my cyan pads.
The cyan pads have a good bite, and finish great.
The tangerine like the cyan stays pretty firm and also has some good cutting for minor swirls.
I found both pads to achieve any desired results depending upon the compound/polish you use.
These pads have become my favorite pads. That's all I use for my Flex. I love them!
Click to expand...
I will be using Griots ROP with 105 w/ cyan hydro pad, then finishing w/ 205 and CCS white pad on my z06. :xyxthumbs:
 
Using the Cyan pad with Menz PowerFinish is AMAZING!!! But I used a Makita.

Just know using a RO on your Vette clear coat is going to take a lot of time and patience.
 
Yes the cc on your vette is very hard. But using 105/205 you'll be fine with the da. Yes it's not going to be as fast as a rotaray, but you'll get nice results pretty quick. Just remember to work a small section at a time approximately 18"x18". May want to consider finishing up with Menz 85rd on a blue LC CCS pad to take the finish to the next level.
 
You must log in or register to reply here.
Back
Top