Coatingsarecrack
Well-known member
- Dec 9, 2018
- 7,918
- 618
Post Your Unpacking Pictures
- Thread starter Marc08EX
- Start date
Coatingsarecrack
Well-known member
- Dec 9, 2018
- 7,918
- 618
Dang that seemed short lived. My Ryobi going on 7+ years of car and household use…. Been waiting for it to die to have an excuse to upgrade.
Did it dy by accidentally jumping off of a high shelf?
Sent from my iPhone using Tapatalk
SNP209
Active member
- Sep 26, 2016
- 951
- 231
It started cavitating out of nowhere. I thought I had a leak but checked all my fittings and they were good.
I was going to purchase the 1.8 gpm ryobi as a replacement but the next day I got a random check in the mail for a class action lawsuit from 2021 that covered more than half the cost of the 2.0
I actually used a little 1.2 gpm greenworks that I keep as a spare to finish washing my car and man can you notice a difference in the gpm immediately.
Brrr
Active member
- Jun 19, 2022
- 344
- 247
I’m not sure what kind of setup you had in your previous PWer, but the Ryobi 1.8 needs an upgraded hose.It started cavitating out of nowhere. I thought I had a leak but checked all my fittings and they were good.
I was going to purchase the 1.8 gpm ryobi as a replacement but the next day I got a random check in the mail for a class action lawsuit from 2021 that covered more than half the cost of the 2.0
I actually used a little 1.2 gpm greenworks that I keep as a spare to finish washing my car and man can you notice a difference in the gpm immediately.
I bought an Uberflex 3/8” off NorthernTool.com for $62 shipped and it came with 2 male threaded ends. That was another $15 for the QC’s to fit. I also bought a new spray gun to try out that was $35 and then a cheap QC for the water hose for $30.
I’m in it about $275… I’m actually getting ready to walk out the door in a few minutes to test all of it out.