Rommel
New member
- Aug 11, 2014
- 86
- 0
Well my CRX has been an on-going project since earlier 2012 and for the past couple days have given here some extra attention. Last year did a garage paint job(I assisted) followed by wet-sanding, compounding & polishing done by myself with 3M Perfect-It products on a rotary. Initially was protected with Ammo Creme Reflective Paste, which was very nice. Later in the year switched to 2 coats of PBL Diamond Surface coating upon discovering Autogeek and was very very impressed with it.
The coating was still looking good & holding up just fine but I wanted to put my new found tools & knowledge to work that I have gained here from Autogeek:xyxthumbs:
I started with:
-Good 'ol fashion wash
-IronX & Nanoskin to clean and prep surface.
-Flex 3401 with 5" LC Orange Hybrid pads with Wolfgang Uber compound to remove old coating & defects
-CarPro Eraser wipedown
-Flex PE8 w/ 3.75" backing plate to run 5" LC Hybrid Gold Jeweling pads using Wolfgang Finishing Glaze
-GG6 w/GG 6" Red Wax pad using PBL Surface Cleansing Polish
-PBL Diamond Surface Coating w/24hr cure time
-2 coats of PBL Synergy Wax(2hrs apart)
No before pics or in progress pics, these are all after.











The coating was still looking good & holding up just fine but I wanted to put my new found tools & knowledge to work that I have gained here from Autogeek:xyxthumbs:
I started with:
-Good 'ol fashion wash
-IronX & Nanoskin to clean and prep surface.
-Flex 3401 with 5" LC Orange Hybrid pads with Wolfgang Uber compound to remove old coating & defects
-CarPro Eraser wipedown
-Flex PE8 w/ 3.75" backing plate to run 5" LC Hybrid Gold Jeweling pads using Wolfgang Finishing Glaze
-GG6 w/GG 6" Red Wax pad using PBL Surface Cleansing Polish
-PBL Diamond Surface Coating w/24hr cure time
-2 coats of PBL Synergy Wax(2hrs apart)
No before pics or in progress pics, these are all after.










