Recent content by Ancient1

I got couple of mine. Had to go to Menards today and took one as I entered and the other sa I was walking out.

I started today with a decon wash (foamed with my IK foamer with M37 coating prep wash let dwell then rinsed and sprayed down with TriX and let dwell and washed with reset.) After it dried I planned on a coat of wax but realized it needed a claying on all the horizontal surfaces (pretty sure it...

I did a wheels off to get some of the crap from my wheel well liners and clean and coat my wheels with 3 layers of MOHS topped with Skin.

I am curious if it is CSL topped with EXO V3 or V4. 1st post says V4 last says v3, I would like to of seen both just because in my limited experience V3 was a better combination.

I have had good luck with P21S Polishing Soap on my exhaust tips but have never tried on painted surface.

I stopped by the VFW and had a couple beers for kind of a celebration it being 50 years to the day I got drafted.

I replaced the just over 3yo battery yesterday and gave my car its 1st wash in over a month.

I have done both and like the epoxy full chip floor best. I have no idea on the longevity of the 8100/Rexthane combination but I am sure it will out last me. The swisstrax tiles I had seem to of faded just a little and was strange walking on them since the didn't lay quite flat and you could...

The one picture looks real similar to my Audi interior.

I got my 1st today. The 2nd will be March 13 7:00 AM

Here is a pic from a couple days ago with the temps not much below freezing. Right now the temp is a 1 degree f and isn't supposed to get above 10 until the 15th with more snow forecast during that time.

Last night after I got back from getting new plates.

Well my car made it one day at least. My son had the garage full last night so I had to park outside till this after noon. Guess what happened lol. So I gave it another WW today.

I was finally able to get my car into the garage on Friday so I decided would give it some prep just before winter hits. On friday I went and got a 40# propane cylinder filled for the heater and pulled the car in and did a WW with n-914 at PW strength. I then did clay the hood since it wasn't...

We are finally making progress on the face lift of my garage. Been close to two weeks since we 1st patched and ground the floor getting ready for a coating. I posted the day we got the chipped epoxy first done but was not a good application, it had spots that the chips didn't fully adhere and...